HOW TO USE OUR TRANSFER PAPER
 
Size 4x5 inch
 
Please read the instructions carefully before use. Improper use can distort/loss the design on clay.
Please follow the below steps to make sure that the design is well transferred on the clay.
 
 
GET STARTED
Condition your clay and roll it onto a tile surface. Make sure that it is well stuck on the tile using an acrylic roller.
Place the paper with the colored/printed side on the clay slab. Roll over the transfer paper with your acrylic roller gently to make sure that the paper is completely stuck to the clay and there are no air bubbles or corners lifting.
 
DISSOLVE THE PAPER
Take your tile with the clay slab on it and hold it under LOW PRESSURE running water from the faucet in your sink.
The paper will start dissolving itself and GENTLY rub the remaining paper away using your fingers until you get a smooth texture. Do not apply too much pressure because your design can be distorted.
Don't cure the clay until it's fully dry. You can use a paper towel and GENTLY dab the clay slab to remove the water but do not apply pressure.
Cut and bake it as usual.
If design appears powdery, wash again after baking, you can apply pressure to the image to remove undissolved paper
 
 
I recommend to use white clay/light clay colors for the best results and the most accurate colors.
 
SEAL THE DESIGN
I recommend sealing your finished piece with resin for a shiny finish or any matte sealant for a matte finish. Sealing your piece will increase the durability of the transferred design.
 
We don’t offer refunds or exchanges for this product due to hygiene reasons but please feel free to let us know if there are damages or breakage upon receipt of this item.
If you need a different size, just shoot us a message.
If you have any questions about sizing or how to use your cutter please contact us.